Final Assignment: Owl 3D Puzzle

I was planning to make a 3D puzzle. Firstly, based on a picture and a tutorial from website, I built a simple owl.

I used Edge Surface to build curves to cut the little owl in to four pieces.

And I created small joints (created a cylinder, use BooleanUnion and BooleanDifference).

I didn’t draw drafts for my design, cuz I wasn’t able to make it complicated but I wanted to. Finally I just made it super simple like Lego pieces.

I left the whole Monday to finish printing, but I didn’t realize that one of the 3D printers was broken and created a disaster:

But luckily, the other printer worked.

So basically, my project works like this:

The complete version is here:

Leave a Reply

Your email address will not be published. Required fields are marked *